3D Multi-Marking Square

New 3D Multi-Marking Square

as a whole new dimension to traditional woodworking squares. When laying outjoinery, you often need to mark both the face and the edge of your board at the same dimension. Most squares have onlya thin shoulder you can use to make a small mark, but aligning and transferring that line invites inaccuracy.

With the 3D Multi-Marking Square,you have two full-length legs you can use when laying out on the face and edge of your stock. That's not all, its geometry makes this tool a stand- up assistant with your machinery setup. If you're tired of being limited to only two dimensions, 

The long legs and wide surfaces keep the tool stable even on thinner stock where a traditional square may flop around.And the base is perfect for registering inside and outside corners. Now, with just one tool, you can lay out complex joinery and check the entire assembly for square.

With your project laid out, the 3D Multi-Marking Square works equally well with your machinery setup, perfectly perpendicular to your table.Its two legs reach past any troublesome table insert,leaving your hands free to make adjustments to your machine.We engraved bright white scales to make seing your blade or bit height easy. And,the thick blade provides a solid reference against a drill bit or band saw blade when adjusting the table square.

They're secured together using high-strength stainless steel screws.We mill a groove precisely in the center of the base's longarmwhich serves twopurposes.Itkeeps the blade perpendicular to the base, and gives youequal shouldersso you can quickly lay out perfectly centered mortise and tenon cheeks.